Dinolift 265RXT - Limit Switches

48
DINO RXT
S24
Non-lockingleverswitch.
Control switch for outrigger 4
S25
Non-lockingleverswitchforplatformlevelling
The levelling operates as the lever switch is turned to the desired direction. The levelling can
be operated with the emergency descent system.
S26
Button for driving with raised boom
As the button is depressed, the boom can be raised during the driving to the level position
or the machine can be driven with the boom in the horizontal position. During the driving the
outriggerlimit-switchesarebypassedwiththisbutton.
S27
The drive mode selector switch.
This switch enables selection between various drive modes for different driving situations.
Position1=2-wheelsteering.
Position2=4-wheelsteering.
Position 3 = crab steering.
Onlytheforemostaxlewithrespecttothedrivedirectionwillturnasthe2-wheelsteeringmode
is selected.
Asthe4-wheelsteeringmodeisselectedbothaxleswillturn,buttherearaxlewillturntothe
opposite direction.
As the crab steering mode is selected all wheels turn to same direction.
S28
Pedal
Act as a Dead man switch. Always depress the pedal before activating any movement. The
movements can be operated only after this.
S29
Control switch for platform swing.
S31
Retracting the telescope
After the SR3 has tripped, the telescope can be retracted by depressing the button.
F13
Automaticfuseforplatformswing(4A).
XS2-A1
Signal unit
Bus module used for controlling the relays and as a connection terminal for the sensors
LIMIT SWITCHES
RK3
Limit switch for transport position
Prevents the operation of the outriggers and the driving device if the boom does not rest on the
transport support.
RK4
Limit switch for outreach
Safetylimit-switchfortheadjustedoperatingrange.
RK5
Limit reach for overload
Backuplimit-switchforthesafetylimit-switchRK4.
Asthislimit-switchoperates,thebusisshiftedtocongestionmodeasregardstotheboom
movementsandtheSR3willtripafterthepredetermineddelay(1,2seconds)
RK6
Safetylimit-switchforthehorizontalpositionoftheboom.
Switches off the raising of the boom at the level plane as the boom is raised during the driving
and the outriggers are in the upper position.
RK7, RK15
Safety limit switch for the telescope chain for the boom.