45
REMOTE CONTROL
When the MODE switch on your remote is in the left-most position,
it controls your DIRECTV receiver. However, you can also program
the AV1, AV2 and TV positions to control other equipment such as
your TV, DVD, VCR or Stereo. From System Setup, select “Remote
Control” and then “Program Remote.” It is helpful to know the
model number as well as the brand of the equipment to produce
the best results when programming the remote. To clear current
AV1, AV2 and TV settings use the “Reset Remote” option.
IR/RF SETUP
Certain remote control models feature RF (radio frequency)
capability. Refer to the model number printed on the top left
corner of your DIRECTV Remote Control. Look for the letter(s) “R”
or “RB” at the end of the model number which indicates that the
remote supports radio frequency. To change your remote method
of transmission from Infrared (IR) signals to RF, select “Remote
Control” and then “IR/RF Setup”. While IR transmission requires a
clear line of sight to the front of the receiver, RF transmission lets
your put your receiver inside a cabinet or behind solid doors and
still be able to command it from up to 200 feet away.
SETTINGS
45
CHAPTER 4 - SETTINGS & HELP
To Next Page
Loading...
Need help?
General
