Dish Antennas - DISH 1000.4 2 - 8
DISH 1000.4 (continued)
Installation Considerations
• All receivers must have MPEG-4 support (ViP-series receivers).
• Provides additional peaking controls for easier installation and peaking.
– Azimuth Cam provides fine-tuning of the azimuth angle.
– Elevation Rod provides fine-tuning of the elevation angle and additional installation stability.
• Nuts and bolts on the dish should be tightened using a torque wrench in a specific order. Follow the manufacturer’s
instructions for the correct order.
• When tightening the azimuth bolts, do not tighten the Azimuth Cam.
• After peaking on 72.7°, confirm signal on 61.5° and 77°.
• The 1000.4 dish antenna uses the same mast and foot as the DISH 500+.
• Mast clamp includes a gripping feature that provides additional installation stability.
• LNBF Arm has a specific installation orientation, indicated by labeling “Top” and “To LNBF”.
• Antenna dimensions: 27.8”W x 22.3”H.
To Next Page
Loading...
