disperator 515A - Page 11

User manual in Original
Doc. ref: 500A_MC_am_en_210602
DISPERATOR AB Tel: 08-724 0160 E-mail: info@disperator.se
Mälarvägen 9, 141 71 Segeltorp Web page: www.disperator.se
11 / 44
10 / 44
Our product range is designed with the user’s needs in focus and meets today’s requirements for
handling of food waste. The high-quality grinding unit of specially alloyed steel together with the unique
and well-proven sealing design between the grinding unit and motor provides the user with many years
of operaonal reliability and low maintenance cost. The disposer’s life span is extended further by the
outer housing of stainless steel EN 1.4301 (AISI 304) and protecon class IP55 for electrical components
as standard.
The wide range of disposer sizes, and where each size ts all models of assemblies, makes it easy to
customize each installaon of disposer to t all workplaces in kitchens onshore as well as at sea. The
Excellent 500-Series disposers may be installed under sinks and washing lines, into tabletops and working
benches or as freestanding separate units. Installaon into an exisng kitchen furniture manufactured by
another supplier is also possible. For CE-marking an approved assembly with protecon above disposer
inlet is needed from Disperator or other manufacturer.
Standard delivery includes a complete start/stop unit with contactor and motor overload protector, and
a complete solenoid valve with line strainer, which for some of the assembly models need to be installed
and connected on site in the kitchen. Cold water will automacally ow when the disposer starts, ushing
the food waste into the grinding chamber, and then into the sewer system or a storage tank.
Food waste disposers within the Disperator Excellent-Series have the Declaraon of Compliance issued by
DNV, verifying compliance with applicable secons of IMO MARPOL consolidated edion 2017 ANNEX V
for disposal of ground food waste into the open sea