disperator 515A - 9.6. Overhaul and Maintenance Intervals

User manual in Original
Doc. ref: 500A_MC_am_en_210602
DISPERATOR AB Tel: 08-724 0160 E-mail: info@disperator.se
Mälarvägen 9, 141 71 Segeltorp Web page: www.disperator.se
44 / 44
9.6. Overhaul and Maintenance Intervals
Descripon: Interval: Refers to:
Cleaning of the machine Aer daily use See secon 8.2 in this user manual
Check of the line strainer in the ush
water pipe
First me aer a month use,
then when needed
See secon 8.3.2, item 3 in this user manual
Prevenve maintenance - small
First me aer a month use,
then year 1, year 4, year 7
…........ etc.
For this maintenance (overhaul) please note
that no parts need to be exchanged. See
secon 9.3 in this user manual in terms of:
*Overhaul of protecon safety,
*Overhaul of assembly and connecons,
*Overhaul of all mechanical and electrical
connecons,
*When needed, training of personal.
Prevenve maintenance - medium
Year 2, year 5, year 8 …........
etc.
* Prevenve maintenance – small according
to above.
* Replacement of rubber seals with Posion
No. P14 and P17 (Spare Part No. -05 and -08)
in secon 9.2 of this user manual.
Prevenve maintenance - large
Year 3, year 6, year 9 …........
etc.
* Prevenve maintenance - medium
according to above.
* Replacement of parts included in Service
Package 1 according to secon 9.2 of this
user manual. If needed due to long and hard
operang mes of disposer, please also
inspect if the carrier (Pos. No. P2, Spare Part
No. -18) as described in secon 9.4, item 16
need to be ordered and exchanged. For those
disposer models that have a large inlet with
noise damping seal (shown as Pos. No. 17 in
the table in the end of secon 9.2), please
also consider if this seal due to wear has
lost its elascity and therefore needs to be
replaced.
Replacement of parts due to wear
Aer approx. 9000 operang
hours
Service package 2 according to secon 9.2 in
this user manual
Exchange of other parts When needed