disperator 515A - 6. Installation Description for the Machine; 6.1. Assembly of the Machine

User manual in Original
Doc. ref: 500A_MC_am_en_210602
DISPERATOR AB Tel: 08-724 0160 E-mail: info@disperator.se
Mälarvägen 9, 141 71 Segeltorp Web page: www.disperator.se
17 / 44
16 / 44
6. Installation Description for the Machine
6.1. Assembly of the Machine
6.1.1. Deployment of the Machine
Unless otherwise requested in your order, the machine is delivered with the legs on a pallet. To
minimize the risk of injury, at least two people must be present when the machine is deployed.
The machine has a net weight according to secon 3.2 above, so the liing equipment (eg
forklis, pallet lis, liing trolleys, liing devices, etc.) to be used must be checked that it can
handle this weight.
Li the machine o the pallet. Carefully then move the machine to the designated installaon
site.
Before lowering the machine to the oor, adjust the four adjustable legs so that the desired
machine height is obtained. To do this, loosen the four locknuts on the machine legs. When the
machine is placed on the oor, check with a spirit level that it is horizontal, and readjust the legs
if necessary. When this is done, ghten the lock nuts on the four machine legs again.
6.1.2. Fixation of the Machine
The machine must be xed so that during jamming and a quick stop (for example if a cutlery
accidentally ends up in the machine) it is not disturbed from its posion due to the torque of the
disposer motor. This can cause unwanted forces on the machine’s connecon to the drain pipe
(see secon 6.3 below) which can cause leakage. If separate ngs can not be arranged for this
xing of the machine, there is an oponal an torque bar for delivery from Disperator for xing
the machine to the longitudinal wall (or corner wall). See secon 5.2 above.
For marine installaon, the machine is instead xed with the help of, for example, plates that are
welded to the oor, whereupon the machine’s legs are placed and screwed onto these plates
according to the pictures below. The machine legs with feet are included as standard in delivery
for marine installaon (see secon 3.2 above), while the plates (if they cannot be arranged
locally) can be ordered as an opon from Disperator.