Controls - 24 100sx Operator’s Manual
Plow
6. Ignition switch Insert key and turn to ON
position to enable rope start.
Turn key to OFF position to
stop engine.
IMPORTANT: Before starting
machine:
• ensure plow control is disengaged
• move speed/direction control to
neutral position
7. Operator presence
switch
Detects when operator is
present.
Press and hold at least one
switch before moving ground
drive control or digging
control out of neutral.
NOTICE: Do not wire or tape operator
presence switch to handlebar or
defeat interlock system in any
manner. Ground drive and digging
controls will not function.
Item Description Notes
c00ic126w.eps
To Next Page
Loading...
