100sx Operator’s Manual Service - 65
50 Hour
50 Hour
Change Engine Oil
Change engine oil every 50 hours or annually,
whichever occurs first. Ensure unit is level and
engine oil is warm.
To drain:
1. Disconnect spark plug wire and keep away
from spark plug (shown).
2. Remove oil drain plug (2). Drain oil into an
approved receptacle.
3. After oil has drained, install and tighten oil
drain plug.
To fill:
1. Clean oil fill area of any debris or dirt.
2. Remove dipstick (1) and wipe with clean
cloth.
3. Slowly pour oil into engine oil fill (1). Fill to
point of overflowing.
4. Insert dipstick.
5. Remove dipstick and check to ensure engine oil level is at the top of full indicator on dipstick.
6. Reconnect spark plug and install and tighten dipstick.
Location Task Notes
Change engine oil and filter GEO, 5.5 qt (5.2 L)
Change hydraulic fluid and filters
Change spark plug
Change air filter
IMPORTANT: Do not turn or tighten
dipstick.
t44om013w.eps
t44om012w.eps
1
2
To Next Page
Loading...
