100sx Operator’s Manual Specifications - 73
100sx
Unless otherwise specified, all figures are for standard equipment only.
Specifications are called out according to SAE recommended procedures. Specifications are general and subject to change without
notice. If exact measurements are required, equipment should be weighed and measured. Due to selected options, delivered
equipment may not necessarily match that described.
Hydraulic System U.S. Metric
Ground drive pump capacity @ 3600 rpm, relief valve setting @ 2,000 psi 2.2 gpm 8.3 L/min
Ground drive pump displacement/revolution
.223 in
3
.556 cm
3
Ground drive motor displacement/revolution
9.6 in
3
157 cm
3
Directional control valve type: open center
Delivery capacity 10 gpm 37.8 L/min
System relief valve setting 2500 psi 172.4 bar
Fluid Capacities U.S. Metric
Fuel tank 1.8 gal 6.8 L
Hydraulic reservoir 3.5 gal 13.2 L
Power Train
Ground drive transmission: hydrostatic, infinitely variable forward and reverse, 3:1 chain drive from
motor to axle
Tires:
16 x 6.5-8 4-ply bar lug
18 x 11.00-8 3-ply knob
Drive line system: belts and sheaves
Vibratory mechanism: eccentric shaft
Noise Levels
Operator 91 dBA sound pressure per ISO 6394
Exterior 104 dBA sound power per ISO 6393
Vibration
Average vibration transmitted to the operator’s hand during normal trenching operation is 15.2 m/sec
2
.
To Next Page
Loading...
