100sx Operator’s Manual Plow - 45
Setup
Position Plow
1. Start plow. See page 34 for start-up procedures.
2. Drive to starting point. Move in line with planned path. See page 35 for operating procedures.
3. Lower plow blade to starting point of path.
4. Turn ignition switch to OFF.
Attach Product
To Pull Product
1. Insert material into pulling grip.
2. Tape grip with duct tape.
To Feed Product
1. Remove cable guide.
2. Feed cable through tube from top to
bottom.
3. Replace cable guide and tighten
fasteners.
4. Secure cable.
NOTICE: Keep everyone away from
material being installed.
Plow_Pull_nobox.eps
Plow_Feed_nobox.eps
To Next Page
Loading...
