Drive - 34 100sx Operator’s Manual
Start Unit
Start Unit
Before operating plow, read engine manufacturer’s starting and operating instructions. Follow instructions
for new engine break-in.
1. Move all controls and switches to the neutral or disengaged position.
2. Open fuel shutoff valve.
3. Insert key into ignition switch and turn to the ON position.
4. Set throttle at low idle.
5. Choke to start cold engine.
6. Pull briskly on starter-rope handle at left side of machine.
• If engine does not start after three pulls on rope start, turn key switch to OFF position and check
for fuel blockage or ignition system problems.
7. Run engine at half-throttle or less for five minutes before operating plow. During warm-up, check that
all controls work properly.
8. Return choke to open position if needed.
Runaway possible. Machine could run over you or others.
Learn how to use all controls. Start and operate only from operator’s
position.
Read operator’s manual. Know how to use all controls.
Your safety is at stake. 273-475
To help avoid injury:
• Read operator’s manual before operating equipment. Follow instructions carefully. Contact your
Ditch Witch
®
dealer for operation information or demonstration.
• Wear hard hat, safety glasses, and other protective equipment required by job. Do not wear jewelry
or loose clothing that can catch on controls.
To Next Page
Loading...
