Service - 60 100sx Operator’s Manual
5 Hour
5 Hour
Change Engine Oil
Change engine oil after 5 hours initially. Ensure
unit is level and engine oil is warm.
To drain:
1. Disconnect spark plug wire and keep away
from spark plug (shown).
2. Remove oil drain plug (2). Drain oil into an
approved receptacle.
3. After oil has drained, install and tighten oil
drain plug.
To fill:
1. Clean oil fill area of any debris or dirt.
2. Remove dipstick (1) and wipe with clean
cloth.
3. Slowly pour oil into engine oil fill (1). Fill to
point of overflowing.
4. Insert dipstick.
5. Remove dipstick and check to ensure engine oil level is at the top of full indicator on dipstick.
6. Reconnect spark plug and install and tighten dipstick.
Location Task Notes
Change engine oil initial service, GEO
IMPORTANT: Do not turn or tighten
dipstick.
t44om013w.eps
t44om012w.eps
1
2
To Next Page
Loading...
