100sx Operator’s Manual Drive - 35
Shut Down
Drive
1. Remove or reposition plow blade for ground clearance.
2. Check that tires are positioned straight or in direction of intended movement.
3. Press and hold operator presence switch.
4. Move ground drive control in desired direction of travel.
5. Adjust throttle for desired speed of travel.
Shut Down
1. When job is complete, move ground drive control to neutral.
2. Return all controls to neutral or disengaged position.
3. Move throttle to low idle for 2-3 minutes to cool.
4. Turn ignition switch to OFF position. If leaving machine unattended, remove key.
5. Close fuel shutoff valve.
EMERGENCY SHUTDOWN: Turn ignition switch to STOP.
NOTICE: Machine should not be parked on a slope unless chocked, blocked, or parking brake
engaged.
To Next Page
Loading...
