Service - 62 100sx Operator’s Manual
10 Hour
Clean Air Filter
Check air filter every 10 hours.
To clean:
1. Remove air filter cover (2) by removing
fastener (1).
2. Remove fastener (3) and filter (4).
3. Remove pre-cleaner (if equipped) from the
filter. To loosen debris, gently tap filter on a
hard surface. If filter is excessively dirty,
replace with a new filter.
4. Wash pre-cleaner in liquid detergent with
water. Allow pre-cleaner to thoroughly air dry.
5. Assemble pre-cleaner to filter.
6. Install seal washer (5) filter, and pre-cleaner
into the base.
7. Install cover and secure.
Check Hydraulic Fluid Level
Check fluid at sight glass every 10 hours. Fluid
should be halfway up sight glass. Add THF at fill
(shown) as necessary. Do not overfill.
NOTICE: Compressed air or water may
damage filter elements.
IMPORTANT: Do not oil pre-cleaner.
t44om015w.eps
1
3
5
2
4
t44om016w.eps
To Next Page
Loading...
