Ditch Witch FX30 - Page 120

FX30/FXT30 Operator’s Manual Service - 119
As Needed
Lube Blower for Long-term Storage
Lubricate blower before long-term storage to help
prevent rust and siezing.
1. Remove plug from fitting at filter.
2. Start engine.
3. Spray light oil into port and run unit for 1-2
minutes.
4. Turn off engine.
Change Blower Relief Air Filter
Check air filter whenever vacuum gauge goes
over 16” (406 mm) of mercury. Change as
needed.
1. Remove clamp.
2. Remove filter and discard.
3. Install new filter.
4. Replace clamp.
Empty Cyclonic Separator Canister
Empty cyclonic separator canister (2) as needed.
Open door and dump tank. Clean out cyclone
through upper access door (1) as needed.
NOTICE: Operating system above 16” (406
mm) of mercury may result in blower damage.
IMPORTANT: Depressurize tank before
emptying cyclonic canister, cleaning filter,
clearing hoses or opening any doors.
j33om064h.epsj33om064h.eps
11
22
j33om065h.epsj33om065h.eps