FX30/FXT30 Operator’s Manual Vacuum and Pothole - 81
Unload to Another Tank
Unload to Another Tank
Optional reverse flow mode can be used to transfer vacuumed material to another tank or disposal site.
1. Securely connect transfer hose to FX tank. Ensure drain/outlet valve on FX tank is closed.
2. Securely connect other end of transfer hose to offboard tank. Ensure inlet valve on offboard tank is
closed and tank is vented.
3. Open FX tank drain/outlet valve. Material may flow into transfer hose.
4. Open offboard tank inlet valve. Move valve handle counterclockwise to engage “reverse flow” mode.
Material will flow into offboard tank.
5. Increase throttle as desired to transfer material.
6. When transfer is complete, close FX tank drain/outlet valve.
7. Close offboard tank inlet valve and disconnect hose from offboard tank inlet valve.
8. Move handle clockwise to “vacuum” mode.
9. Open FX tank drain/outlet valve. Material will empty from transfer hose.
10. Close FX tank drain/outlet valve.
11. Disconnect transfer hose from FX tank.
Misuse of machine can cause death or serious injury.
Read and understand operator’s manual and all other safety instructions
before use.
273-475
To help avoid injury:
• Keep unit in “vacuum” mode unless pressure is needed.
• Restrain hose prior to pressurization. Unrestrained hose may cause property damage, injury or
death.
• Do not open fitting cams or valves when tank is pressurized. Flying debris, plugs and doors can
cause injury or death.
• Do not open tank door while tank is pressurized.
• Do not use pressure to clear clogs in vacuum hose.
System may be pressurized. If over pressurized, death or
serious injury can occur. Exercise and clean relief before each use.
270-
2736
To Next Page
Loading...
