Service - 130 FX30/FXT30 Operator’s Manual
10,000 Mile
10,000 Mile
Truck
Check Mounting Bolts and Springs
Check mounting bolts and springs (shown,
underneath and both sides) every 100 hours for
looseness and damage. Springs (1) should be 3”
(76 mm). Loosen or tighten bolt to adjust spring
length. Tighten all other indicated hardware to 240
ft•lb (325 N•m).
Check Accessory Mounting Bolts
Check accessory (fender, hitch, water heater, bumper, skid extension, front tool rack) mounting bolts every
100 hours for looseness and damage. Tighten or replace as needed.
Location Task Notes
Truck Check mounting bolts and springs
Check accessory mounting bolts
To Next Page
Loading...
