FX30/FXT30 Operator’s Manual Service - 89
Service Precautions
Working Under Raised Tank Door
1. Locate door lock tools in tool storage area and bring
to rear of tank.
2. Raise tank door completely.
3. Pin door lock tools into place as shown.
4. Lower tank lid until load is supported by door lock
tools.
Welding Precaution
Washing Precaution
Crushing weight can cause death or serious injury. Pin
door lock on linkage before servicing.
270-5216
NOTICE: Welding can damage electronics.
• Disconnect battery to prevent damage to battery. Do not turn off battery disconnect switch with
engine running, or alternator and other electronic devices may be damaged.
• Connect welder ground clamp close to welding point and make sure no electronic components are
in the ground path.
• Always disconnect the Engine Control Unit ground connection from the frame, harness connections
to the ECU, and other electronic components prior to welding on machine or attachments.
NOTICE: Water can damage electronics. When cleaning equipment, do not spray electrical components
with water.
To Next Page
Loading...
