JT30 /JT30 All Terrain Operator’s Manual Controls - 24
Set-Up Console
CMW
Item Description Notes
1. Tracker control key To allow tracker operator to
stop thrust and rotation, move
key to enable position (up).
To override tracker control
mode, move key to disable
position (right).
IMPORTANT: Remove key and keep
in tracker operator’s possession.
2. Cold start wait indicator Lights when intake air pre-
heater is operating.
Wait until light goes off before
starting engine.
3. Ignition switch To start engine, insert key and
turn clockwise.
To stop engine, turn key
counterclockwise.
IMPORTANT:
• Restart engine with ignition switch
after it has been turned off with
tethered control remote engine
stop switch.
• If wrenches are engaged when
engine is stopped with ignition
switch, wrenches will release and
then engage when unit is started.
4. Left track switch To move forward, press top.
To move backward, press
bottom.
IMPORTANT: Use track switches only
if tethered control is inoperable.
c00ic147h.eps
To Next Page
Loading...