Ditch Witch JT30 - Page 25

Controls - 25 JT30 /JT30 All Terrain Operator’s Manual
Set-Up Console
CMW
5. Right track switch To move forward, press top.
To move backward, press
bottom.
IMPORTANT: Use track switches only
if tethered control is inoperable.
6. Engine shutdown
override switch
If engine shutdown indicator
comes on, turn ignition switch
to STOP and press to delay
engine shutdown for 30
seconds.
This control allows a temporary
override of engine shutdown.
NOTICE: After 30 seconds, engine
will again shut down unless fault
condition has been cleared on
diagnostic gauge.
IMPORTANT: See “Electronic
Controlled Engine Overview” on
page 169 for more information on Tier
3 engines.
7. Left stabilizer control To raise, pull up.
To lower, push down.
IMPORTANT: Lower left and right
stabilizers to the ground together,
then adjust individually.
WARNING: Crushing weight could
cause death or serious injury. Use
proper procedures and equipment or
stay away.
8. Right stabilizer control To raise, pull up.
To lower, push down.
IMPORTANT: Lower left and right
stabilizers to the ground to stabilize
unit and then adjust for side-to-side
stability.
WARNING: Crushing weight could
cause death or serious injury. Use
proper procedures and equipment or
stay away.
Item Description Notes
c00ic148h.eps
c00ic178h.eps