Controls - 37 JT30 /JT30 All Terrain Operator’s Manual
Left Control Console
CMW
Item Description Notes
1. Fluid pump speed
switch
For high speed, press top.
For low speed, press bottom.
High speed delivers more flow at
lower pressure.
Low speed delivers less flow at higher
pressure.
2. AutoCarve switch To enable autocarve, press
top.
To deactivate autocarve,
press bottom.
Two-speed thrust is not allowed in
autocarve mode.
Cruise control is not available in
autocarve mode.
Autocarve is disabled while front
wrench is closed.
3. Console/Work light
switch
To turn on, press top.
To turn off, press bottom.
4. Engine throttle switch To increase speed, press top.
To enable autothrottle mode,
leave switch in top position.
To disable autothrottle mode,
return switch to center after
desired speed is reached.
To decrease speed, press
bottom.
Autothrottle mode slows the engine to
low throttle after 15 seconds of
inactivity involving thrust, rotation,
drilling fluid flow, or pipeloader
functions. To return to high speed,
activate thrust, rotation, drilling fluid,
or an add/remove pipe cycle.
c00ic151h.eps
To Next Page
Loading...