23
IP1812EN
2. Declaration of incorporation of partly
completed machinery
(Directive 2006/42/EC, Annex II-B)
The manufacturer ASSA ABLOY Entrance Systems AB, with headquarters in Lodjursgatan 10, SE-
261 44 Landskrona, Sweden, declares that the Ditec CUBIC6-CUBIC6H-CUBIC6HV automation
for swing gates:
- is designed to be installed on a manual gate to form a machine pursuant to Directive 2006/42/
EC. The manufacturer of the motorised gate must declare conformity with Directive 2006/42/
EC (annex II-A) prior to initial machine start-up;
- complies with the applicable essential safety requirements indicated in Annex I, Chapter 1 of
the Directive 2006/42/EC;
- complies with the Electromagnetic Compatibility Directive 2014/30/EU;
- complies with the RED Directive 2014/53/EU;
- the technical documentation complies with Annex VII-B of the Directive 2006/42/EC;
- the technical documentation is managed by the Technical Office of Ditec Spa (with headquarters
in Largo U. Boccioni 1 – 21040 Origgio (VA) – ITALY) and is available upon request, sending an
e-mail to info@ditecautomations.com ;
- a copy of the technical documentation will be given to competent national authorities, following
a suitably justified request.
Landskrona, 11-11-2020 Matteo Fino
(Chairman)
2.1 Machinery Directive
Pursuant to the Machinery Directive (2006/42/EC), the installer who motorises a door or gate has
the same obligations as the manufacturer of machinery and as such must:
- prepare the technical data sheet which must contain the documents indicated in Annex V of the
Machinery Directive;
(the technical data sheet must be kept and placed at the disposal of competent national authori-
ties for at least ten years from the date of manufacture of the motorised door or gate);
- draw up the EC Declaration of Conformity in accordance with Annex II-A of the Machinery Direc-
tive and deliver it to the customer;
- affix the EC marking on the motorised door or gate, in accordance with point 1.7.3 of Annex I of
the Machinery Directive.
To Next Page
Loading...
Need help?
General
