15
IP1639EN • 2012-07-31
DETACH AND DELIVER TO THE CUSTOMER
8.1 General safety precautions
The following precautions are an integral and essential part of the product and must be supplied to the user.
Read them carefully since they contain important information on safe installation, use and maintenance.
These instructions must be kept and forwarded to all possible future users of the system.
This product must only be used for the specic purpose for which it was designed.
Any other use is to be considered improper and therefore dangerous.
The manufacturer cannot be held responsible for any damage caused by improper, incorrect or unreasonable
use. Avoid operating in the proximity of the hinges or moving mechanical parts.
Do not enter within the operating range of the motorized door while it is moving.
Do not block the movement of the motorized door since this may be dangerous.
Do not allow children to play or stay within the operating range of the motorized door.
Keep remote controls and/or any other control devices out of the reach of children in order to avoid possible
involuntary activation of the motorized door.
In the event of fault or malfunctioning of the product, turn off the power supply switch, do not attempt to repair
or intervene directly and contact only professionally competent personnel.
Failure to comply with the above may cause a dangerous situation.
All cleaning, maintenance or repair work must be carried out by professionally competent personnel.
To ensure that the system works efciently and correctly, the manufacturer’s indications must be complied with
and routine maintenance of the motorized door must be performed by professionally competent personnel.
In particular, regular checks are recommended in order to verify that the safety devices are operating correctly.
All installation, maintenance and repair work must be documented and made available to the user.
For the correct disposal of electric and electronic equipment, waste batteries and accumulators, the user
must take such products to the designated municipal collection facilities.
In the event of a fault or blackout, release any electric lock,
insert the key and turn it anticlockwise (in the direction
indicated by the arrow on the gearmotor). Manually open
the gate.
To block the door wings again, turn the key clockwise (in
the opposite direction to the arrow on the gearmotor). To
facilitate the operation, move the door wing slightly.
WARNING: the door wing block and release opera-
tions must be performed with the motor idle.
8.2 Manual release instructions
OBBI
8. Operating instructions
RIGHT PISTON
LEFT PISTON
DITEC S.p.A.
Via Mons. Ban, 3
21042 Caronno Pertusella (VA) - ITALY
Tel. +39 02 963911 - Fax +39 02 9650314
www.ditec.it - ditec@ditecva.com
To Next Page
Loading...
