Dittmann TEN 250 - Electromagnetic Immunity Information

35
Guidelines and manufacturer's declaration – electromagnetic emissions
The model TEN 250 is intended for use in an environment as specified below. The customer or
the user of the model TEN 250 should ensure that it is used in such an environment.
Electromagnetic
interference
measurements
Compliance
Electromagnetic environment – guideline
HF emissions
according to CISPR 11
Group 2
The model only uses HF energy for
its internal operation. Therefore, its HF
emissions are very low, which most probably
do not cause any malfunctions in nearby
electronic installations.
TEN 250
HF emissions
according to CISPR 11
Class B
The model is intended for use in all
facilities, including residential environments
and such environments that are directly
connected to the public power supply, which
also supplies buildings that are used for
residential purposes.
TEN 250
Harmonic current
emissions according
to IEC 61000-3-2
Not applicable
Emission of voltage
fluctuations/flicker
according to IEC
61000-3-3
Not applicable
Table 1 – Instruction and manufacturer's specifications – electromagnetic emissions – for all
INSTALLATIONS and SYSTEMS (see 6.8.3.201 a) 3).
Instruction and manufacturer's specifications – electromagnetic emissions
The (INSTALLATION or the SYSTEM) is designed for the use in the electromagnetic
environment described below. The customer or the user of the (INSTALLATION or the
SYSTEM) should ensure that it is used in such an environment.
Emission test
Compliance
Electromagnetic environment –
instruction
HF emissions
CISPR 11
Group 2
The (INSTALLATION or the SYSTEM) only uses
HF energy for its internal operation.
Therefore, only very low HF emissions occur,
which most probably do not cause any
malfunctions in nearby electronic installations.
21.0 Information regarding electromagnetic immunity
ELECTRIC IMMUNITY
GB
4. PJN157-14_GA-GB_HHD_TEN250_31.03.14
Montag, 31. M󾾠rz 2014 12:10:44