Page 19 of 72
VEND MOTOR WIDE COLUMN
Mounted on the Vender with the Vend Switch on the left side (See Fig. 3). The Linkage and Drive Arm assembly
is used to connect the Vend Motor to the Oscillator. (See Fig. 4)
Vend Motor Switch
804,100,69x.x1 - Single Price
804,100,73x.x1 - SIID
Nyliner (Rear Stack)
801,803,17x.x1
Vend Motor - Wide Column
609,070,60x.x3 - Single Price
609,070,70x.x3 - SIID
Fig. 3
A Drive Pin 900,901,94x.x1
B. Drive Arm, Zinc 801,200,95x.x1
C. Washer 900,700,60x.x1
D. Linkage Arm, Zinc 801,201,59x.x1
E. Nyliner (Top) 901,803,16x.x1
F. Truss Screw #8-32x½ 900,301,64x.x1
G. Nyliner (Bottom) 901,804,77x.x1
Fig. 4
Oscillator Assembly
609,070,50x.x3 - Bottles
609,070,40x.x3 - Cans (shown)
Nyliner (front stack)
901,804,23x.x1
To Next Page
Loading...
