©2012 DJI Innovations. All Rights Reserved. - 12 -
Target Line: Line between aircraft and current target.
The waypoint number of one package.
Retry one package timeout.
Sys_setAltitude offset: Set up the altitude offset.
Height: Height mode.
Elevation: Elevation mode.
Sys_setData Record Folder: Include both Log and Mission Folders, for saving log files and flight
route files.
4. Language(语言): Click to change language, English or Chinese.
Check for Update: Update software here.
About: Check your DJI Ground Station version here.
6. Enter location: Go to the location of your input.
7. Fly Trace: Click to show the trace of aircraft.
8. PathExtrude: Click if you want to see flight Path Extrude during mission editing.
9. Map Details: Click to see map details.
10. Instrument Board: Click if you want to display instrument board.
11. Editor: Click if you want to display mission editor.
12. Continue: If you switch into autopilot mode from waypoint mode, click Pause then click Continue,
the aircraft will continue the remaining (Unfinished) mission.
13. Pause: Mission pause.
14. Serial port selection.
15. Connect: Click to connect to main controller.
16. Aircraft: Click to find aircraft location.
17. Real-time coordinates of aircraft, you can copy the data.
18. One Key Takeoff: Click to take off the aircraft.
19. Home Point: Find your home location.
20. Real-time coordinates of home location, you can copy the data.
21. Set Home Point: Change your home point.
22. Go Home: Click to go home.
23. To show Real mode or Simulation mode.
24. Signal strength: Shows the connection state between controller and ground station.
25. GPS: Real-time GPS signal quality.
To Next Page
Loading...