©2012 DJI Innovations. All Rights Reserved. - 36 -
Find and set the waypoint action properties according to the following procedures:
STEP1: Click , the Mission Status will show Editing Mission label upon the Mission Editor.
STEP2: Edit flight mission.
STEP3: Select the waypoint either in 3D-Map or in the EditingMission menu, and get Waypoint
action, shown as Fig..
STEP4: Give the proper parameters explained in Editor: Period, RepeatTime, StartDelay, and
RepeatDistance. Set RepeatTime and RepeatDistance zero to disable the GP-Servo Action.
Tips:
Use SetAllActioninMission properties to setup the sequence interval. For example: 0 means action
property is applied to no waypoint; 1 means action property is applied to every waypoint; 2 means action
property is applied to every two waypoints; 3 means action property is applied to every three waypoints,
etc.
Fig. ① Fig. ②
To Next Page
Loading...