dji Agras T25

AGRAS T50/T25
Unmanned Aircraft Flight Manual
©
2023 DJI All Rights Reserved.
17
Using the Remote Controller
Powering the Remote Controller On and Off
Both the internal battery and external battery can be used to supply power to the remote
controller. The battery level is indicated via the battery level LEDs on the remote controller or
on the external battery. Follow the steps below to power on the remote controller:
1. When the remote controller is powered off, press the power button once to check the
current battery level of the internal battery. Press the battery level button on the external
battery to check the current battery level of the external battery. If the battery level is too
low, recharge before use.
2. Press the power button once, then press and hold to power on the remote controller.
3. The remote controller beeps when powered on. The status LED glows solid green when
linking is complete.
4. Repeat Step 2 to power off the remote controller.
Charging the Batteries
1. Use the DJI 65W Portable Charger to charge both the internal and external batteries
simultaneously.
B
A B
A
Power Outlet
(100-240 V, 50/60 Hz)
Use the provided charger to charge the remote controller. Otherwise, use a locally
certified USB-C charger with a maximum rated power and voltage of 65 W and 20 V.
Fully charge and discharge the internal and external batteries of the remote
controller at least once every three months. The battery will deplete when it is stored
for an extended period.