dji Agras T25

AGRAS T50/T25
Unmanned Aircraft Flight Manual
46
©
2023 DJI All Rights Reserved.
Takeo/Landing
The Combination Stick Command (CSC) listed below is used to start and stop the motors. Make
sure you perform the CSC in one continuous motion. The motors begin to accelerate at an idle
speed. Release both sticks simultaneously. Take off immediately once the motors are spinning, or
else the aircraft may lose balance, drift, or even takeoff by itself and risk causing damage or injury.
Takeo
Push both sticks to the bottom inner or outer corners to start the motors.
OR
Landing
To land, pull down on the throttle stick to descend until the aircraft touches the ground. There
are two methods to stop the motors.
Method 1: when the aircraft has landed, push and hold the throttle stick down. The motors will
stop after three seconds.
Throttle Stick (left stick in Mode 2)
Method 2: when the aircraft has landed, push the throttle stick down, and perform the same
CSC that was used to start the motors. Release both sticks once the motors have stopped.
OR
Spinning propellers can be dangerous. Stay away from spinning propellers and motors.
DO NOT start the motors in confined spaces or where there are people nearby.
Maintain control of the remote controller as long as the motors are running.
DO NOT stop the motors mid-flight unless in an emergency situation where doing so
will reduce the risk of damage or injury.
It is recommended to use Method 1 to stop the motors. When using Method 2 to stop
the motors, the aircraft may roll over if it is not completely grounded. Use Method 2
with caution.
After landing, power off the aircraft before turning off the remote controller.