dji Agras T25

AGRAS T50/T25
Unmanned Aircraft Flight Manual
86
©
2023 DJI All Rights Reserved.
Enable/Disable RTK
Before each use, make sure that the RTK signal source is correctly set to either D-RTK 2 Mobile
Station or Network RTK. Otherwise, RTK cannot be used for positioning. Go to Operation View in
the app, tap , and select RTK to view and set.
Disable RTK Positioning if RTK is not in use. Otherwise, the aircraft is not able to take off when
there is no differential data.
Using with the DJI D-RTK 2 Mobile Station
1. Refer to the D-RTK 2 Mobile Station User Guide for more information about completing the
linking between the aircraft and the mobile station and setting up the mobile station.
2. Power on the mobile station and wait for the system to start searching for satellites. The
RTK status icon on top of the Operation View becomes green to indicate that the aircraft
has obtained and used the differential data from the mobile station.
Using with the Network RTK Service
The Network RTK service uses the remote controller instead of the base station to connect to an
approved Network RTK server for differential data. Keep the remote controller powered on and
connected to the internet when using this function.
1. Make sure the remote controller is connected to the internet.
2. In the app, go to Operation View, tap
and then RTK to select RTK Signal Type to Custom
Network RTK, and input the network information.
3. Wait for the remote controller to be connected with the Network RTK server. The RTK
status icon at the top of the Operation View will turn green, indicating that the aircraft has
obtained and used the RTK data from the server.