dji Agras T25

AGRAS T50/T25
Unmanned Aircraft Flight Manual
©
2023 DJI All Rights Reserved.
39
Altitude Zone
When the GNSS signal is strong, the aircraft approaches the
boundary of the Altitude Zone. If it is higher than the altitude limit,
the aircraft decelerates and hovers in place.
When the GNSS signal changes from weak to strong, the app starts
a 100-second countdown. Once the countdown is over, the aircraft
will descend and hover below the altitude limit.
Free Zone The aircraft flies normally with no restrictions.
Semi-Automatic Descent: All stick commands except the throttle stick command and
the RTH button are available during descent and landing. The aircraft motors will turn
off automatically after landing. It is recommended to fly the aircraft to a safe location
before the semi-automatic descent.
Radio Frequency Environment
1. Avoid using wireless devices that use the same frequency bands as the remote controller.
2. When using with multiple aircraft, including T50, T25, and other aircraft, make sure that the
distance between each aircraft is more than 10 m to avoid interference.
3. The sensitivity of the radar module may be reduced when operating several aircraft within a
short distance. Operate with caution.
4. Be alert when flying near areas with magnetic or radio interference. These include, but are
not limited to, high voltage lines, large scale power transmission stations or mobile base
stations, and broadcasting towers. Failing to do so may compromise the transmission
quality of this product or cause transmission errors which may affect flight orientation and
location accuracy. The aircraft may behave abnormally or go out of control in areas with too
much interference.
5. If the RTK dongle is used for field planning, the module should be disconnected from the
remote controller after planning is completed. Otherwise, it will affect the communication
performance of the remote controller.
Use of Launch and Recovery Equipment
Not applicable.
Distance to Control Station
When taking off or landing, the aircraft should be more than 10 m away from the remote
controller and operator to ensure safety. Maintain visual line of sight with the aircraft at all
times.