2 Usage
2.1 Pair and Activate
When powered on for the rst time, follow the prompt on the bike screen to complete
pairing and activating. Tap Skip and you can ride for trial without activation. After the trial
distance has run out, follow the steps below to pair and activate before you can continue
to use it.
1. Press and hold the power button of the control display to power on.
2. Swipe up on the screen to enter Settings and tap Pair to App to view the QR code.
3. Make sure Bluetooth and network are enabled on your mobile device. Open Avinox
App, then tap Pair and scan the QR code to pair.
2.2 Device Updates
When connected with the drive system, there will be a prompt in the app if a version
update is available. It is recommended to update to the latest version to get a better user
experience.
Make sure there is enough battery power before updating. During the update, make sure
the signal on your phone is strong, and that the Bluetooth connection remains stable. DO
NOT move the bike or power o the control display.
2.3 Charging
Charging the Battery
• Make sure to use the ocial charger to charge the battery.
• While charging, make sure not to move the bike and place the charger on a level
surface.
1. Open the charging port cover and connect the charger.
2. During charging, the bike screen will display the current battery level.
3. Unplug the charger and close the port cover after the battery is fully charged. DO NOT
pull the power cable by force when removing the charger.
DJI Avinox User Manual
10 © 2024 DJI All Rights Reserved.
To Next Page
Loading...