dji AVINOX - Customizing Assist Modes; Ride Data Recording Mode

To Next Page

To Previous Page

The assistance will shut o automatically when stop pressing or the speed exceeds 6

km/h.

Stationary Gear Shifting

Stationary gear shifting is supported when using Walk mode. After activating Walk mode,

press the shift lever and lift the rear wheel, then press twice to shift gears quickly.

• Only use Walk mode when pushing the bike. Using in inappropriate situations

may cause accidents and personal injury.

• Ensure to keep your body away from the rotating crank and pedals to avoid

damage when using Walk mode to assist pushing the bike and gear shifting.

Customizing Assist Modes

Open the app and tap Custom Assist Modes, users can view and adjust the parameters

of Auto, Eco, Trail, and Turbo according to their preferences and scenarios.

• Make sure the drive system is powered on and connected to the app when

setting the assist modes.

2.6 Ride Data Recording Mode

Users can set the ride data recording mode on Settings of the control display.

Recording Mode: Select between Auto, Manual and Notication.

• Auto: Recording will start automatically upon detecting riding. Users can also set a

speed, and the recording will start when the speed exceeds the set value.

• Manual: Start recording manually and tap to pause the recording during riding.

• Notication: Users can set a speed, and the control display will prompt whether to

start recording when the speed exceeds the set value.

Auto-Pause: When enabled, users can set a speed for pausing recording. Data recording

will be paused if riding at speed lower than the set threshold.

DJI Avinox User Manual