dji Focus - Prepare the Motor

DJI FOCUS
User Manual
©
2015 DJI. All Rights Reserved.
11
Prepare the Motor
The motor gear can be mounted on either side of the motor. To remove the gear, loosen the
knob at the center the gear. Ensure the gear is mounted securely.
2. Push the knob away from the clamp and open up the clamp. Slide and remove the two
adapters on the clamp.
The motor can be clamped to a 15 or 19 mm support rod. To clamp the motor to a 19 mm
support rode, rst remove the two adapters on the clamp:
1. Loosen the knob and remove the quick-release mount.
1
2