dji Focus - Settings; Calibration

©
2015 DJI. All Rights Reserved.
15
[1] Battery Level
[2] Focus Wheel Travel Percentage
[3] Focus Wheel Travel Bar
[4] Main Menu
[5] Calibration Menu
[6] Wireless Signal Strength
Calibration
The motor has to be calibrated every time it is turned on.
If your camera lens has mechanical limits, use auto calibration. Otherwise, use Manual-Remote
or Manual-Hand calibration.
Auto
On the remote controller, select Calibrate
Auto. The motor gear will rotate in each direction in
turn to locate the mechanical limits of your camera lens. When the calibration is complete, select
Back to apply the calibration or Stop to cancel.
Manual-Remote
Select Calibrate
Manual-Remote Start to begin. Hold down the up arrow to rotate the lens
in one direction, and select OK when it reaches the desired upper limit. Next, press the down
arrow to rotate the lens in the other direction, and select OK when it reaches the desired lower
limit.
Manual-Hand
Select Calibrate
Manual-Hand Start to begin. Rotate the lens manually to the desired upper
and lower limits of your camera lens, and select OK to conrm the limits.
When the calibration is complete, select Back to apply the calibration or Stop to cancel.
TIPS
Be sure to recalibrate the motor every time it is turned on.
Settings
When both the remote controller and motor are turned on. The OLED screen of the remote
controller will display the following information.
50.0%
Calibrate Menu
[1]
[2]
[3]
[4][5]
[6]