dji GUIDANCE - Mounting the Guidance Sensors

Guidance User Manual
©
2015 DJI. All Rights Reserved.
11
Mounting the Guidance Sensors
Mounting Requirements
GuidanceSensorsshouldbemountedonthefront,rear,left,rightandbottomofthecarrier.Thegure
below shows these directions with respect to the DJI MATRICE.
ThevedefaultmountingpositionsfortheDJIMATRICEarefront,rear,left,rightandbottom.
Forotherintelligentsystems,mountanywherefromonetoveoftheGuidanceSensorswherenecessary.
If the carrier you are using is an aircraft, the downward facing Guidance Sensor must be mounted.
Mounting Procedures
Mount the Guidance Sensors to the designated positions on your carrier. The following mounting
procedures use the DJI MATRICE as an example.
1. Mounting the downward facing Guidance Sensor:
Fix the Guidance brackets to the expansion bay of the DJI MATRICE. Then mount the Guidance
Sensor onto the brackets. Ensure the VBUS port of the Guidance Sensor points to the front of the
carrier (in the direction of the arrow shown below). Failure to do so may lead to critical system errors
andunintendedightbehavior.
Rear
Up
Down
Left
Right
Front
If you are using other intelligent systems, set the position offset between the Guidance Core
and the intelligent system in the DJI Guidance Assistant software.
Check the Guidance Core regularly to ensure it is not loose.
TheGuidancesystemisnotwaterprooforoil-proof.