dji GUIDANCE - Configuration

Guidance User Manual
18
©
2015 DJI. All Rights Reserved.
Conguration
Conguration Guidelines
Adjust the settings according to the type of intelligent system that you are using.
1.Standard:Standardparametersfor DJIightcontrolsystems,withdefaultsettingssetfor theDJI
MATRICE. The position offset parameters do not need to be modified if you are using the DJI
MATRICE with standard mounting positions. Otherwise, if used with other robotic platforms or the
DJIMATRICEbutwith non-standardmountingpositions,set thepositionoffsetparameters forthe
Guidance Sensors.
2. DIY: Customized parameters for other intelligent systems.
Useasuitablepowersupplyduringthecongurationprocess.
ADJIaccountisrequiredwhenusingtheDJIGuidanceAssistantforthersttime.
Conguration Procedures
Run the DJI Guidance Assistant software and complete the setup according to the instructions in the
application.
Viewing the System Status
1. Select the
Work Type
under “View”.
1). If you are using the DJI MATRICE, select “Standard” and complete the settings.
2). If you are using other intelligent systems, select “DIY” and complete the settings.
2. Check the
Previews
for each of the Guidance Sensors to ensure they are working properly.
Setting the Parameters
1. Standard Settings
IfyouareusingaDJIightcontrolsystem,congurethesettingsunder“Standard”.
1). If you are using the DJI MATRICE with standard mounting positions. Select “DJI MATRICE” as the
Aircraft Type
. Enable or disable the
Obstacle Sensing Mode
based on your preference.