dji MATRICE 300 RTK - Page 75

©
2020 DJI All Rights Reserved.
75
MATRICE 300 RTK User Manual
Wide Camera View
This section mainly sets out the differences with zoom camera. Refer to the Gimbal Camera View
section for more details.
Zoom Frame: After switching to a wide-angle camera as the main view, the zoom frame will display the
eld of view and camera zoom rate.
Thermal Camera View
This section mainly sets out the differences with zoom camera. Refer to the Gimbal Camera View
section for more details.
1 2 3 4
5
1. Palette/Isotherm: displays the highest and lowest temperature measurement values of the current
view. Tap to choose between different infrared temperature measurement palettes, or enable the
isotherm to set temperature measurement intervals. Note that if the measured area exceeds the
maximum or minimum temperature measurement values of the current view, the setting will not take
eect.
2. Gain Modes: Using the H20T as an example, the high gain mode provides more accurate
temperature measurements with a measurement range from -40° to 150° C (-40° to 302° F), while