76
©
2020 DJI All Rights Reserved.
MATRICE 300 RTK User Manual
low gain mode supports a wider temperature measurement range of -40° to 550° C(-40° to 1022°
F). Note that the range is only a theoretical value, and even though the thermal camera can measure
temperatures beyond the range, the value may deviate substantially.
3. Display Mode: The infrared screen is set as single infrared view by default. Tap to enable or disable
side-by-side view. When enabled, both the footage captured by the infrared thermal camera and the
zoom camera will be displayed side by side.
4. FFC Calibration: Tap to execute FFC calibration. FFC calibration is a function of the infrared thermal
camera that optimizes image quality for easy observation of temperature changes.
5. Zoom (Thermal Camera): Using the H20T as an example, tap to adjust the digital zoom of the infrared
thermal camera with a maximum zoom capability of 8x. Tap and hold to zoom directly to 1x.
Laser Rangender (RNG)
1. Tap to enable the RNG.
2. The cross hair in the center of the lens will turn red, which means the laser rangender is aiming at
the target and measuring the altitude of the target and distance between the target and the aircraft.
The latitude and the longitude of the target can be obtained after a PinPoint is created on the target.
3. The linear distance between the target and the aircraft.
4. The altitude between the target and the aircraft.
5. The horizontal distance between the target and the aircraft.
RNG positioning is limited by factors such as the GNSS positioning accuracy and gimbal
attitude accuracy. The GNSS position, horizontal distance, Navigation Display, and AR
projection are provided for reference only.
When the zoom camera is aiming, the cross hairs will be an upright cross, while with the
wide-angle camera or thermal camera it will turn into an X.
1
2
3
4
5
To Next Page
Loading...
