©
2019 DJI All Rights Reserved.
29
Mavic Mini User Manual
Optimal Transmission Zone
The signal between the aircraft and the remote controller is most reliable when the antennas are
positioned in relation to the aircraft as depicted below.
strong weak
Linking the Remote Controller
The remote controller is linked to the aircraft before delivery. Linking is only required when using a new
remote controller for the rst time. Follow these steps to link a new remote controller:
1. Power on the remote controller and the aircraft.
2. Launch DJI Fly. In camera view, tap the icon and select Shortcuts and Connect to Aircraft, or
press and hold the power button of the remote controller for more than four seconds. The remote
controller beeps continuously indicating it is ready to link.
3. Press and hold the power button of the aircraft for more than four seconds. The aircraft beeps once
indicating it is ready to link. The aircraft beeps twice indicating linking is successfully.
Make sure the remote controller is within 0.5 m of the aircraft during linking.
The remote controller will automatically unlink from an aircraft if a new remote controller is linked to
the same aircraft.
Fully charge the remote controller before each ight.
If the remote controller is powered on and not in use for ve minutes, an alert will sound. After six
minutes, the aircraft automatically powers o. Move the control sticks or press any button to cancel
the alert.
Adjust the mobile device clamp to ensure the mobile device is secure.
Make sure the antennas of the remote controller are unfolded and adjusted to the proper position to
achieve optimal transmission quality.
Repair or replace the remote controller if damaged. A damaged remote controller antenna greatly
decreases performance.
Fully charge the battery at least once every three months to maintain battery health.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
