©
2019 DJI All Rights Reserved.
39
Mavic Mini User Manual
Stopping Motors Mid-ight
Stopping motors mid-ight will cause the aircraft to crash. The motors should only be stopped mid-
ight in an emergency situation such as if a collision has occurred or if the aircraft is out of control and
is ascending/descending very quickly, rolling in the air, or if a motor has stalled. To stop the motors
mid-ight use the same CSC that was used to start the motors.
Flight Test
Takeoff/Landing Procedures
1. Place the aircraft in an open, at area with the aircraft status indicator facing towards you.
2. Turn on the aircraft and the remote controller.
3. Launch DJI Fly and enter the camera view.
4. Wait until the aircraft status indicator blinks green indicating that the Home Point has been recorded
and it is now safe to y.
5. Gently push the throttle stick to take o or use auto-takeo.
6. Pull the throttle stick or use auto-landing to land the aircraft.
7. After landing, push the throttle stick down and hold. The motors stop after three seconds.
8. Turn o the aircraft and remote controller.
Video Suggestions and Tips
1. The pre-ight checklist is designed to help you y safely and to ensure that you can shoot video
during ight. Go through the full pre-ight checklist before each ight.
2. Select the desired gimbal operation mode in DJI Fly.
3. Shoot video when ying in P-mode or C-mode.
4. DO NOT y in bad weather conditions such as when it is raining or windy.
5. Choose the camera settings that best suit your needs.
6. Perform ight tests to establish ight routes and to preview scenes.
7. Push the control sticks gently to keep the aircraft movement smooth and stable.
Method 1 Method 2
OR
To Next Page
Loading...
Need help?
General
Weight and Dimensions
