dji T50 - Disclaimer; Warnings

4
©
2024 DJI All Rights Reserved.
Disclaimer
Carefully read this entire document and all safe and lawful practices provided by DJI before
using this product for the first time. Failure to read and follow instructions and warnings
may result in serious injury to yourself or others, damage to your DJI product, or damage to
other objects in the vicinity. By using this product, you hereby signify that you have read this
document carefully and that you understand and agree to abide by all terms and conditions
of this document and all relevant documents of this product. You agree that you are solely
responsible for your own conduct while using this product and for any consequences thereof.
DJI accepts no liability for damage, injury, or any legal responsibility incurred directly or
indirectly from the use of this product.
DJI is a trademark of SZ DJI TECHNOLOGY CO., LTD. (abbreviated as “DJI”) and its affiliated
companies. Names of products, brands, etc., appearing in this document are trademarks
or registered trademarks of their respective owner companies. This product and document
are copyrighted by DJI with all rights reserved. No part of this product or document shall be
reproduced in any form without the prior written consent or authorization of DJI.
This disclaimer is available in various languages. In the event of divergence among dierent
versions, the English version shall prevail. The final interpretation of this document and all
related documents of this product belongs to DJI. This content is subject to change without
prior notice. For up-to-date product information, visit www.dji.com and go to the product page
for this product.
Warnings
1. The T50/T25 Spreading System is only compatible with the DJI AGRAS
TM
T50/T25 aircraft
when the rmware of the aircraft supports the spreading system. Refer to the Specications
section for more information about compatibility. DO NOT use it with other products or for
non-agricultural purposes.
2. The spreading system is compatible with dry materials that have a diameter between 0.5
to 5 mm. DO NOT use with other materials. If used with other materials, the operating
performance will be negatively affected and the spreading system may be damaged. All
materials must be used in strict accordance with the instructions for those materials.
3. The max load of the spread tank depends on the takeoff weight of the aircraft. DO NOT
overload. Refer to the Specications section for more information.
4. When connecting the cables, make sure the connection is correct and secure. Operate with
caution to avoid damaging the cables.
5. Make sure that the hopper gate and spinner disk function normally before each use.
6. Operate with caution to avoid injury caused by sharp or moving mechanical parts.
7. While spreading, maintain a safe distance from the spreading system to avoid injury.
8. DO NOT attempt to disassemble any part of the spreading system that has already been
mounted prior to shipping. Unless this user guide states that part may be detached.
Otherwise, the ingress protection performance will be aected.
9. Under stable laboratory conditions, the spreading system has a protection rating of IP67 (IEC
standard 60529). This protection rating is not permanent and may reduce over an extended
period of time due to aging and wear. The product warranty does not cover water damage.