v.220411 | 25
STARTING YOUR EQUIPMENT
1. Position your machine on flat, dry ground.
2. Make sure the fuel shut o valve is in the “ON” position.
3. Move the choke control lever to the “CHOKE” position (should only be needed if the engine
is cold).
4. Move the throttle control lever to the “FAST” position.
5. RECOIL START: Turn the ignition switch to the “ON” position. Grasp the recoil starter handle
and slowly pull until you feel resistance. Let the cord retract a little bit then pull the cord
rapidly to start the engine. One or two pulls usually starts the engine.
6. ELECTRIC START: Turn and hold the key in the start position until the engine starts, then let
the key return to the run position.
7. Move the choke control lever (if used for cold engine), slowly back to the “RUN” position
when the engine is running well.
8. If the machine has not been running (cold engine), warm up the engine by running it at half
throttle for 3 to 4 minutes, then advance the engine throttle control to the maximum speed.
STOPPING YOUR EQUIPMENT
1. Move the throttle lever to “IDLE”.
2. RECOIL START: Slide the gas lever to the left to shut the engine o.
3. ELECTRIC START: Turn the key to the “OFF” position.
ENGLISH
To Next Page
Loading...
