DKS 9100 - Default Chapter; Table of Contents

To Next Page

To Previous Page

TABLE OF CONTENTS

Section 1 – Installation

1.1 Specifications ...........................................................................................................................................1

1.2 Mounting Positions

1.2.1 Front Position Pad Mount.........................................................................................................2

1.2.2 Front Position Post Mount........................................................................................................2

1.2.3 Rear Position Pad or Post Mount.............................................................................................3

1.2.4 Center Position Post Mount .....................................................................................................3

1.3 Mounting Options

1.3.1 Pad Mounted Operators...........................................................................................................4

1.3.2 Post Mounted Operators..........................................................................................................5

1.4 Operator Installation

1.4.1 Pad Mounted Operators...........................................................................................................6

1.4.2 Post Mounted Operators..........................................................................................................6

1.5 Chain Installation

1.5.1 Front – Pad Mount ...................................................................................................................7

1.5.2 Front – Post Mount...................................................................................................................8

1.5.3 Rear – Pad or Post Mount........................................................................................................9

1.5.4 Center – Post Mount ................................................................................................................10

1.6 Warning Sign Installation..........................................................................................................................11

Section 2 – Wiring

Conduits ...................................................................................................................................................13

2.1 High Voltage Connections........................................................................................................................14

2.2 Control Wiring...........................................................................................................................................15

2.3 Secondary Entrapment Protection Device Wiring

2.3.1 Non-Contact Sensors...............................................................................................................16

2.3.2 Contact Sensors.......................................................................................................................17

2.4 Loop Detector Wiring................................................................................................................................18

2.5 Gate Tracker™ Connections....................................................................................................................19

2.6 Auxiliary Devices

2.6.1 Alarm Reset Switch..................................................................................................................20

2.6.2 Auxiliary Stop Switch................................................................................................................20

2.7 Master / Slave Wiring

2.7.1 Operator Interface ....................................................................................................................21

2.7.2 Secondary Entrapment Protection Device Wiring....................................................................22

2.8 Terminal Identification and Description

2.8.1 Main Terminals.........................................................................................................................23

2.8.2 Auxiliary Terminals...................................................................................................................24

Section 3 – Adjustments

3.1 Circuit Board Adjustments........................................................................................................................25

3.2 Switch Settings.........................................................................................................................................26

3.2.1 SW 1 (Left Switch) Description and Function...........................................................................27

3.2.2 SW 2 (Right Switch) Description and Function ........................................................................27

3.3 Limit Adjustment.......................................................................................................................................28

3.4 Inherent Reverse Adjustment

3.4.1 Reverse Sensitivity Adjustment................................................................................................29

3.4.2 Clutch Adjustment....................................................................................................................30