When heating function was switched ON, LED
displays the temperature setting value and shifts
to real value in 5 seconds.
When the heating function is switched OFF and
the hotplate temperature is still above 50℃,
LED displays HOT, otherwise LED displays 0.
5. Trial run
• Make sure the required operating voltage and power
supply voltage match.
• Ensure the socket must be properly grounded.
• Plug in the power cable，ensure the power is on and begin
initializing.
• Add the medium into the vessel with an appropriate
stirring bar.
• Place vessel on the work plate.
• Set the target stirring speed and begin.
• Set the target temperature and start heating (hotplate
model).
• Stop the heating and stirring functions.
If these operations above are normal, the device is ready to
operate. If these operations are not normal, the device may
be damaged during transportation, please contact
manufacturer/supplier for technical support.
To Next Page
Loading...
