KEYLESS ENTER-N-GO — IGNITION
NOTE:
In case the ignition switch does not change with the push of a button, the key fob may
have a low or dead battery . In this situation, a back up method can be used to operate the
ignition switch. Put the nose side of the key fob (side opposite of the Emergency Key)
against the ENGINE ST AR T/STOP button and push to operate the ignition switch.
Starting
Perform the following starting procedure
with the key fob inside the vehicle:
1. While pushing the brake pedal, push the
ENGINE START/STOP button once. If
the engine fails to start, the starter will
disengage automatically after 10 sec-
onds.
2. To stop the cranking of the engine prior
to the engine starting, push the button
again.
Stopping
1. Bring the vehicle to a complete stop.
2. Shift the Transmission to P ARK (P).
3. Push the ENGINE ST ART/STOP button
once. The ignition switch will return to the OFF position.
NOTE:
If the transmission is not in PARK and the vehicle is in motion, the ENGINE START/STOP
button must be held for two seconds with the vehicle speed above 5 mph (8 km/h) before
the engine will shut off.
Accessory Positions With Engine Off
NOTE:
The following functions are with the driver’ s foot off of the Brake Pedal (transmission in
PARK).
ENGINE START/STOP Button
GETTING STARTED
16
To Next Page
Loading...
