CAUTION!
Do not run the booster vehicle engine above 2000 rpm since it provides no charging
benefit, wastes fuel and can damage booster vehicle engine.
6. Once the engine is started, remove the jumper cables in the reverse sequence:
Disconnecting The Jumper Cables
1. Disconnect the negative (-) end of the jumper cable from the remote negative (-) post
of the discharged vehicle.
2. Disconnect the opposite end of the negative (-) jumper cable from the negative (-) post
of the booster battery.
3. Disconnect the positive (+) end of the jumper cable from the positive (+) post of the
booster battery .
4. Disconnect the opposite end of the positive (+) jumper cable from the remote positive
(+) post of the discharged vehicle.
5. Reinstall the protective cover over the remote positive (+) post of the discharged
vehicle.
If frequent jump-starting is required to start your vehicle you should have the battery and
charging system tested at your authorized dealer .
CAUTION!
Accessories plugged into the vehicle power outlets draw power from the vehicle’s
battery, even when not in use (i.e., cellular devices, etc.). Eventually, if plugged in long
enough without engine operation, the vehicle’ s battery will discharge sufficiently to
degrade battery life and/or prevent the engine from starting.
MANUAL PARK RELEASE
WARNING!
Always secure your vehicle by fully applying the parking brake, before activating the
Manual Park Release. Activating the Manual Park Release will allow your vehicle to roll
away if it is not secured by the parking brake or by proper connection to a tow vehicle.
Activating the Manual Park Release on an unsecured vehicle could lead to serious
injury or death for those in or around the vehicle.
In order to move the vehicle in cases where the transmission will not shift out of P ARK
(such as a dead battery), a Manual Park Release is available.
WHAT TO DO IN EMERGENCIES
223
To Next Page
Loading...
