Conditions That Will Cause The Engine To Start Automatically While In Autostop Mode:
• The transmission selector is moved out of DRIVE.
• To maintain cabin temperature comfort.
• HVAC is set to full defrost mode.
• HVAC system temperature or fan speed is manually adjusted.
• Battery voltage drops too low .
• Low brake vacuum (e.g. after several brake pedal applications).
• STOP/ST AR T OFF switch is pressed.
• A STOP/ST AR T system error occurs.
To Manually Turn Off The Stop/Start System
1. Push the STOP/START OFF switch (lo-
cated on the switch bank). The light on
the switch will illuminate.
2. The “STOP/ST AR T OFF” message will
appear in instrument cluster display
within the Stop/Start section. Refer to
“Instrument Cluster” in “Understanding
Your Instrument Panel” in your Owner’s
Manual on
www.dodge.com/en/owners/manuals for
further information.
3. At the next vehicle stop (after turning off
the STOP/ST AR T system), the engine
will not be stopped.
4. The STOP/ST ART system will reset itself
back to an ON condition every time the ignition is turned off and back on.
To Manually Turn On The Stop/Start System
Push the STOP/ST ART OFF switch (located on the switch bank). The light on the switch
will turn off.
For complete details on the Stop/Start System, refer to the “Stop/Start System” in the
“Starting And Operating” section located in your Owner’s Manual on
www.dodge.com/en/owners/manuals for further information.
STOP/START Off Switch
OPERATING YOUR VEHICLE
96
To Next Page
Loading...
