If the vehicle is not in PARK and the driver turns off the engine, the vehicle may AutoPark.
AutoPark will engage when all of these conditions are met:
• Vehicle is equipped with a rotary shifter and an 8-speed transmission
• Vehicle is not in PARK
• Vehicle Speed is 1.2 MPH (1.9 km/h) or less
• Ignition switched from RUN to ACC
NOTE:
For Keyless Go equipped vehicles, The engine will turn off and the ignition switch will
change to ACC mode. After 30 minutes the ignition switches to OFF automatically , unless
the driver turns the ignition switch OFF.
If the vehicle is not in PARK and the driver exits the vehicle with the engine running, the
vehicle may AutoPark.
AutoPark will engage when all of these conditions are met:
• Vehicle is equipped with a rotary shifter and an 8-speed transmission
• Vehicle is not in PARK
• Vehicle speed is 1.2 MPH (1.9 km/h) or less
• Driver’ s seat belt is unbuckled
• Driver’ s door is ajar
• Brake Pedal is not depressed
The MESSAGE “AutoPark Engaged Shift to P then Shift to Gear”will display in the
instrument cluster.
NOTE:
In some cases the ParkSense graphic will be displayed in the instrument cluster . In these
cases, the shifter must be returned to “P” to select desired gear .
If the driver shifts into PARK while moving, the vehicle may AutoPark.
AutoPark will engage ONLY when vehicle speed is 1.2 MPH (1.9 km/h) or less.
The MESSAGE “Vehicle Speed is Too High to Shift to P”will be displayed in the
instrument cluster if vehicle speed is above 1.2 MPH (1.9 km/h).
WARNING!
If vehicle speed is above 1.2 MPH (1.9 km/h), the transmission will default to
NEUTRAL until the vehicle speed drops below 1.2 MPH (1.9 km). A vehicle left in the
NEUTRAL position can roll. As an added precaution, always apply the parking brake
when exiting the vehicle.
OPERATING YOUR VEHICLE
89
To Next Page
Loading...
