•
Only one Cruise Control feature can operate at a
time. For example, if Fixed Speed Cruise Control is
enabled, Adaptive Cruise Control will be unavailable,
and vice versa.
CRUISE CONTROL
When engaged, the Cruise Control takes over accelera-
tor operations at speeds greater than 20 mph
(32 km/h).
The Cruise Control buttons are located on the right side
of the steering wheel.
WARNING!
Cruise Control can be dangerous where the system
cannot maintain a constant speed. Your vehicle could
go too fast for the conditions, and you could lose con-
trol and have an accident. Do not use Cruise Control
in heavy traffic or on roads that are winding, icy,
snow-covered or slippery.
To Activate
Push the on/off button to activate the Cruise Control.
“CRUISE CONTROL READY” will appear in the instru-
ment cluster display to indicate the Cruise Control is on.
To turn the system off, push the on/off button a second
time. “CRUISE CONTROL OFF” will appear in the instru-
ment cluster display to indicate the Cruise Control is off.
The system should be turned off when not in use.
WARNING!
Leaving the Cruise Control system on when not in use
is dangerous. You could accidentally set the system
or cause it to go faster than you want. You could lose
control and have an accident. Always leave the sys-
tem OFF when you are not using it.
To Set A Desired Speed
Turn the Cruise Control on. When the vehicle has
reached the desired speed, push the SET (+) or SET (-)
button and release. Release the accelerator and the
vehicle will operate at the selected speed. Once a
speed has been set, a message “CRUISE CONTROL SET
TO MPH (km/h)” will appear indicating what speed was
set. A cruise indicator lamp, along with the set speed,
will also appear and stay on in the instrument cluster
when the speed is set.
To Vary The Speed Setting
To Increase Or Decrease The Set Speed
When the Cruise Control is set, you can increase speed
by pushing the SET (+) button, or decrease speed by
pushing the SET (-) button.
U.S. Speed (mph)
•
Pushing the SET (+), or SET (-) button once will
result ina1mphspeed adjustment. Each subse-
quent tap of the button results in an adjustment of
1 mph.
•
If the button is continually pushed, the set speed
will continue to adjust until the button is released,
then the new set speed will be established.
Metric Speed (km/h)
•
Pushing the SET (+), or SET (-) button once will
result ina1km/hspeed adjustment. Each subse-
quent tap of the button results in an adjustment of
1 km/h.
•
If the button is continually pushed, the set speed
will continue to adjust until the button is released,
then the new set speed will be established.
To Accelerate For Passing
While the Cruise Control is set, press the accelerator to
pass as you would normally. When the pedal is
released, the vehicle will return to the set speed.
USING CRUISE CONTROL ON HILLS
The transmission may downshift on hills to maintain the
vehicle set speed.
Cruise Control Buttons
1 — On/Off
2 — CANC/Cancel
3 — SET (+)/Accel
4 — RES/Resume
5 — SET (-)/Decel
104 STARTING AND OPERATING
To Next Page
Loading...
Need help?
General
